Dinamap Pro 100V2 Especificaciones descargar pdf (Pagina 21)

Getting Started

Any time the paper is loaded, the printer automatically prints

a test strip with the DINAMAP

PRO name on it. If no print is

visible on the paper, check that the paper roll has been

installed in the correct position (refer to diagram). To tear off

the printout, use a slight sideways action to pull the paper

sharply up across the serrated edge of the door.

Printer Alarms

If the Monitor is switched on with no paper installed or with

the printer door open, the message “No Paper” will appear

next to “PRNT” in Area 3 of the LCD. When new paper is

installed and the printer door is closed, the message will

change to “Manual” for Manual print or “Auto” for Auto

print, depending on the status before the paper change.

If the paper runs out during a print request or if an attempt is

made to print when no paper is installed, the message

“Printer - No Paper” will appear in Area 2 of the LCD and an

audible alarm will sound. In addition, the message “No

Paper” will appear next to “PRNT” in Area 3 of the LCD. To

clear the alarm, press the rotor. The message in Area 3 of the

LCD will remain until new paper is installed and the printer

door is closed. (See “Using the Menu System.”)

Installing new paper will cause the DINAMAP PRO header

to be printed, thereby confirming that the paper is installed

correctly and that the printer is operational. The message

next to “PRNT” in Area 3 of the LCD will change to “Auto”

or “Manual” to identify the operating mode of the printer.

After power-off, the operating mode of the printer returns

to the previous user-selected setting (Auto or Manual)

unless specified otherwise in the Print button under the

Service Button.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 107 108

Sin comentarios

Dinamap Pro 100V2 Especificaciones Pagina 21