Dinamap Pro 100V2 Especificaciones descargar pdf (Pagina 105)

105

Appendix G

Host Port Connector (rear panel)

WARNING! Auxiliary equipment connected to the

DINAMAP

PRO Monitor will result in the formation of an

electromedical system and thus, must comply with the

requirements of EN 60601-1-1/ IEC 601-1. All host port

signals are NON-ISOLATED and should be connected to

equipment conforming to IEC-601-1, configured to comply

with IEC 601-1-1 ONLY. Where isolation of data

communication is required, GE Medical Systems Information

Technologies part number ILC232 should be used. If external

alarm control is required, GE Medical Systems Information

Technologies part number 487208 (Isolated Remote Alarm

Cable Assembly) should ALWAYS be used. Please refer to

the Information Sheet included with the isolated remote

alarm cable for details.

Note: When using remote alarm, the PRO Monitor should be

considered the primary alarm source. The secondary alarm is

used for secondary purposes only.

Pin NumberFunction

1Ground

2 Inverted TTL Transmit Data

3 Inverted TTL Receive Data

4 Fused +5 volts

5No connection

6No connection

7Ground

8Remote Alarm

9 RS232 Request to Send (RTS)

10 RS232 Clear to Send (CTS)

11 RS232 Transmit Data (TxD)

12 No connection

13 RS232 Receive Data (RxD)

14 No connection

15 No connection

1 2 ... 100 101 102 103 104 105 106 107 108

Sin comentarios

Dinamap Pro 100V2 Especificaciones Pagina 105