Dinamap Pro 100V2 Especificaciones descargar pdf (Pagina 14)

charging. If the battery is not inserted, the external power

indicator LED will flash (short flash approx. every 4 sec).

When the Monitor is running on battery power, a battery

icon appears in LCD area 3 (toggling with the time indicator)

indicating the charge status.

During battery-only operation, the yellow battery power

indicator LED (17) will light. When the battery becomes

discharged beyond the low battery threshold, the indicator

will begin to flash, and the Monitor will sound warning beeps

every 30 seconds. At this point, the Monitor should be

connected to an AC outlet to recharge the battery. If the

Monitor continues to be used without charging the battery,

the message WARNING: THE BATTERY IS TOO LOW FOR

MONITOR TO FUNCTION. TURN MONITOR OFF

appears. The Monitor shuts down all functions until it is

turned off and the battery is recharged or replaced. To run

the Monitor on AC power, it must be powered off and then

on again.

Battery charging will take place as long as the Monitor

remains connected to an external AC power source. A

battery that is fully discharged can be fully recharged in 1

hour 50 minutes when the Monitor is switched off or 8 hours

if the Monitor is switched on.

Notes

• To prolong the life of the battery, keep the Monitor

connected to an AC outlet whenever possible. NEVER

allow the battery to become completely discharged. A

fully charged battery will power the Monitor for

approximately 2 hours and should survive between 200

and 500 charge/discharge cycles. When it is necessary

to replace the battery, refer to the “Compatibility Table

and Reorder Codes” listed in Appendix D. To ensure full

charge cycles, replace only with a recommended

battery. If the Monitor is to be stored for some time, first

charge the battery and then remove it and store it

separately from the Monitor.

• For continued safety, use only a power cord of listed

type SJT, three-conductor, min. No. 18 AWG, terminated

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Sin comentarios

Dinamap Pro 100V2 Especificaciones Pagina 14